<< Click to Display Table of Contents >> Navigation:  LCR.iQ Product Manual > Installation > Remote Controls - Start, Stop & Print

Before setting up this feature, first install the hardware by connecting one or more momentary contact switches to the digital input(s)–either on the I/O board or the SENSEiQ board. Both boards use connector J11 for the digital inputs.

 

To verify that the push button has been connected successfully, go to the Diagnostics screens. While the button is pressed, the box corresponding to that digital input should be yellow in color.

 

To configure the software to use this feature, go to the I/O Setup screens and find the corresponding Digital Input. Use the Up and Down arrows to highlight that input, and then press Enter. Multiple inputs may be used for the same purpose, if desired.

 

Options:

 

•Remote End/Print – This ends the delivery (if a delivery is active). Otherwise, prints a duplicate ticket of the previous delivery.

•Remote Start – Checks the start conditions and then begins a delivery

•Remote Stop – Pauses the delivery (if a delivery is active).